PROTEOR dynacity 1A510 Notice D'utilisation page 6

Notes:
- Increasing equinus provides a more dynamic alignment. It increases energy return at step completion.
- If the foot seems too long during transfer to the forefoot or if heel support is too flexible, you have to position the foot
behind the socket.
- If heel support seems to hard, or if the foot seems too short during transfer to the forefoot, you have to position the
foot ahead of the socket.
5 – Finishing : To avoid rubbing noises, pull the sock up to the basis of the pyramid and fix it with a fine string for
example.
The malleolar clips shown in the following table ensure connection to the cosmetic shin foam and allow to remove the
foot easily and rapidly.
Installation : Cut the cosme-
malleolus contour. Inside the foam mill a space that will receive the selected connecting part and the foot part protru-
ding from the shell, and at the same time take care that thickness be sufficient to allow for sticking. Position the malleo-
lar clip carefully and clip it into the cosmetic foam. Clean contact surfaces with isopropyl alcohol and stick the malleolar
clip on the foam with XC090 neoprene glue. After drying, finish the outer shape as usually.
6– Product life :
This component has been tested in accordance with standard ISO 22675, the cyclical test of 2 million cycles
corresponds to a use of 2 to 3 years depending on the patient activity.
An annual check of the knee by a CPO is recommended.
7- Maintenance :
The foot shell, the sock and the malleolar clip are the only foot components that may need to be replaced (if worn out,
lost, ...)
Foot shell :
The foot shell can be removed and installed again using 1A40019 shoe-horn.
Use exclusively the spare kit 1A60020-D22 including the shell, the sock and the malleolar clip.
8– Advice for use, maintenance and safety
Clean the foot shell with a slightly damp cloth or sponge.
Use temperature : - 20°C / + 60°C.
No maintenance operation such as lubrication, work on the screws or other parts is required for this foot
except for the operations indicated in §7 that must be performed by the CPO.
A use of the foot that does not adhere to your CPO's recommendations can damage foot components
(carrying heavy loads for example).
In case of an abnormal behaviour of your foot, or if you feel changes in your foot features, or if the foot
sustained a hard shock, contact your CPO.
The presence of sand, particles or any foreign body inside the foot could alter its behaviour and damage it.
After use in water or in a very dusty environment :
Remove the foot shell and take off the sock.
Rinse the foot and the other parts thoroughly with clear water to eliminate particles (mud, sand, ...).
Dry the different items before replacing the sock and the shell.
All manuals and user guides at all-guides.com
Foot size (cm)
Product Nr
tic foam to the desired length, position the foam on the foot and draw the
Side Size in cm
22 to 25 26 to 27 28 to 30
1A40013 1A40014 1A40015
1A51099-0818- Page 6/20
1A40019