Paramètres Du Restricteur D'échappement - Travis Industries DVS EmberGlo Manuel Du Propriétaire

Table des Matières

Publicité

Installation (for qualified installers only)
Paramètres du restricteur d'échappement
Utilisez un tourne-écrou de 1/4
"pour desserrer les vis qui fixent
Use a 1/4" nut driver to loosen
le déflecteur au haut de la
the screws that secure the baffle
chambre de combustion. Faites
to the top of the firebox. Slide
glisser le déflecteur légèrement
the baffle slightly forward until
vers l'avant jusqu'à ce que les
the screw heads are in line with
têtes de vis soient alignées
the keyhole slots . Lower the
avec les fentes en trou de
baffle and remove from the
serrure. Abaissez le déflecteur
firebox. (Re-install baffle after
et retirez-le de la chambre de
the restrictor has been
combustion. ( Réinstaller le
adjusted).
déflecteur une fois le restricteur
ajusté).
Faites glisser le restricteur dans la bonne position
Slide the restrictor to the correct position (consult the vent
(consultez le tableau de ventilation à droite pour
chart to the right to determine the proper setting for your
déterminer le réglage approprié pour votre installation).
installation). The screw location indicates the restrictor
L'emplacement de la vis indique la position du restricteur.
position.
(stock) Position # 1
Position # 2
Position # 3
Position # 4
Position # 5
Arrière du foyer
Back of Firebox
Desserrez les 2 vis sur le restricteur d'échappement.
Loosen the 2 screws on the exhaust restrictor. Slide
Faites glisser le restricteur à la position correcte du
the restrictor to the correct restrictor position then
restricteur, puis serrez les vis pour fixer le restricteur.
tighten the screws to secure the restrictor. In this
Dans cette illustration, le restricteur est en position 2.
illustration, the restrictor in position 2.
In this example, the restrictor is set in the #3 position.
Dans cet exemple, le restricteur est
Tighten the screws to secure the restrictor.
réglé sur la position # 3. Serrez les
vis pour fixer le restricteur.
© Travis Industries
1/4" Nutdriver
5/24/2021 – 1537-FR
Position #5
Position #4
Position #3
Position #2
Position #1
(Stock)
DVS EG GSR2
15
40 Feet
(max.)
35 Feet
30 Feet
25 Feet
20 Feet
16 Feet (Min.)
15 Feet
10 Feet
5 Feet
0 Feet

Publicité

Table des Matières
loading

Table des Matières