GRAUPNER mc-19 tiFS Mode D'emploi page 10

control briefl y, and the value will be displayed in inverse form. Turn the rotary control to adjust output power
All manuals and user guides at all-guides.com
within the range 1 to 5, then press the rotary control again to save the set value. The value is now displayed
again in normal form to confi rm your selection.
Hopping mode:
We recommend Mode 4 for use in Germany. Hopping Modes 2 and 3 are no longer available with the tiFS
system. To set the Hopping Mode, press the rotary control briefl y, and the value will be displayed in inverse
form. Turn the rotary control to select one of the modes 1, 4 or 5, then press the rotary control again to save
the set value. The value is now displayed again in normal form to confi rm your selection.
Caution: in Hopping Mode 1 the telemetry function is not active.
Telemetry cycle:
2.4 GHz S E T T I N G S
RX battery warning
Output power
Hopping mode
Telemetry cycle
ACT
2.4 GHz S E T T I N G S
RX battery warning
Receiver not in
Output power
programming mode
Hopping mode
Telemetry cycle
ACT
sage "Receiver not in programming mode", and it will be impossible to carry out the save process.
2.2. Fail Safe settings:
At this point you can defi ne the fail-safe settings for all channels. The two options are a pre-selected position
(Pos) or "hold mode" for the last position.
by pressing the rotary control. If you select "Position", move the corresponding transmitter control to the desi-
red fail-safe position; otherwise select "Hold". Now move the cursor to the
fail-safe response time to any value in the range 1 to 5 seconds by repeatedly pressing the rotary control.
Finally move to "STO" and save (store) the setting by pressing the rotary control → the STATUS LED on
the receiver glows green.
Switch the receiver off and on again, and your Graupner|tiFS system is ready for use.
If you forget to set the receiver to programming mode, you will see the message "Receiver not in program-
ming mode", and it will be impossible to carry out the save process.
WARNING: after any changes at the Fail-Safe screen you must always save the fail-safe settings (receiver
in programming mode), otherwise the transmitter screen will no longer display the active setting!
07
4.7V
5
4
0.25s
STO SEL
4.7V
5
4
0.25s
STO SEL
The telemetry cycle is the time inter-
val which defi nes how frequently the
telemetry signals are sent back to the
transmitter.
If you wish to adjust the telemetry cycle,
the receiver must fi rst be set to pro-
gramming mode by holding the BIND
button on the receiver pressed in while
you switch the unit on → the STATUS
LED glows red.
Press the rotary control to save the va-
lue → the STATUS LED on the receiver
glows green. Switch the receiver off and
on again, and your Graupner|tiFS sys-
tem is ready for use.
If you forget to set the receiver to pro-
gramming mode, you will see the mes-
If you wish to adjust the Fail Safe po-
sitions, the receiver must fi rst be set
to programming mode by holding the
BIND button on the receiver pressed
in while you switch the unit on → the
STATUS LED glows red.
In the Fail Safe menu, use the rotary
control to select the channel you wish
to adjust, then select the desired setting
symbol, and you can set the
Manual Graupner|tiFS