Important - Hendi 201428 Mode D'emploi

• Reinstalling the rear cover (6) by fixing the screws
(8) using a screw driver (supplied).

Important

1. Please dispose of the drained pump oil according
to the environmental regulations.
Preparations before use
• Remove all protective packaging and wrapping.
Check to make sure the appliance is undamaged
and the completeness of the accessories. In case
of incomplete delivery and damages. Do not use
the machine and contact supplier (See ==> War-
ranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
Operation
• Select the proper size of vacuum bag. (Bag width
of 260mm for item 201428; 300mm for item
201435). Allow a minimum of 3 ~ 4 cm of extra
spacing at the top to ensure well sealing.
• With the lid (1) kept open, insert a power plug to
a suitable electrical power outlet "OFF" will be
shown on the digital display (F). Press ON/OFF
button (A) to enter into ready state.
• Next, press SET button (D) to select VACUUM
TIME, SEAL TIME and MARINATE TIME, adjust
the time of each process by using the increase/
decrease button (E).
B) Draining procedures
• Take a collection container and place it beneath
the oil draining port which is covered by the hex
cap screw.
• Loosen the hex cap screw anti-clockwise by us-
ing the wrench (supplied).
• After all the oil is drained, screw the cap back on
clockwise and tighten it.
2. After re-filling pump oil, please place the ma-
chine in a horizontal position. Do not tip the
machine over.
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resistant surface that is safe from water
splashes.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 10 cm around the appli-
ance.
• Add oil to the vacuum pump.
See below for the setting range of different oper-
ations:
1) Vacuum Time: 5 ~ 90 seconds (With 5 seconds
interval)
2) Seal Time: Set up to 6 seconds (With 0,5 second
interval)
3) Marinate Time: 9 ~ 99 minutes (One cycle last for
9 minutes, can be set up to 11 cycles)
• Put the food in a vacuum bag. Then, put the whole
bag under the fixing clamp (10) inside the cham-
ber (9) of the machine. Please make sure that the
opening of the vacuum bag is entirely and prop-
erly under the seal bar (11) for sealing. And the
whole vacuum bag is locked by the clamp (10)
inside the chamber (9).
EN
7