Important - Hendi MACHINE PROFI LINE 410 Mode D'emploi

Adding and draining vacuum pump oil
Add oil to the pump if the following situations occur.
Important! Make sure the pump oil is above MIN
marking and check regularly.
1. Before first use, the pump needs to be filled with
oil (Supplied).
2. When the oil level is below the MIN marking.
3. When the performance of the machine deteri-
orates.
4. Drain out and re-fill the pump with oil every six
months.
A) Adding oil procedures
• Use the screw driver (supplied) to loosen the
screws (8) of the rear cover (6), remove the cover
to expose the pump.
• Twist off the screw cap anti-clockwise using a
tool (not included).
• Add pump oil using the oil bottle (supplied) until
the oil level is above the MIN marking.
• Tighten the screw cap clockwise using a tool (not
included).
• Reinstalling the glass cover (6) by fixing the
screws (8) using a screw driver (supplied).

Important

1. Please dispose of the drained pump oil according
to the environmental regulations.
Preparations before use
• Remove all protective packaging and wrapping.
Check to make sure the appliance is undamaged
and the completeness of the accessories. In case
of incomplete delivery and damages. Do not use
the machine and contact supplier (See ==> War-
ranty).
• Clean the appliance before use (See ==> Cleaning
and Maintenance).
• Make sure the appliance is completely dry.
B) Draining procedures
• Take a collection container and place it beneath
the oil draining port which is covered by the hex
cap screw.
• Loosen the hex cap screw anti-clockwise by us-
ing the wrench (supplied).
• After all the oil is drained, screw the cap back on
clockwise and tighten it.
• Reinstalling the lower glass cover (6) by fixing the
screws using a screw driver (supplied).
2. After re-filling pump oil, please place the ma-
chine in a horizontal position. Do not tip the
machine over.
• Place the appliance on a horizontal, stable and
heat resistant surface that is safe from water
splashes.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 10 cm around the appli-
ance.
Note: Add pump oil (supplied) between the MAX
and MIN level for the first use.
EN
7