Hendi 201428 Mode D'emploi page 9

Cleaning and Maintenance
Attention: Always unplug the machine from the electrical power outlet and let it cool down completely
before cleaning & storage.
Cleaning
• Never immerse the machine in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
Pump oil
• Check the colour of the pump oil regularly
through the display (7). The oil should be clear,
bright and above the MIN level.
Storage
• Before storage, always make sure the machine
is disconnected from the electrical outlet and
cooled down completely.
Troubleshooting
If the machine does not function properly, please check the below table for the solution. If you are still un-
able to solve the problem, please contact the supplier/service provider.
Problems
The machine does not switch on.
The vacuum bag is not vacuum and /
or sealed completely.
Vacuum bag loses vacuum after being
sealed.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• If the pump oil becomes muddy and darken, it
means that the oil contains impurities and need
to be replaced.
• Change the pump oil for at least every 6 months.
• Store the machine in a cool, clean and dry place
and make sure the lid is closed and secured with
the clamp.
Possible cause
Power plug is not connected properly
with the electrical power outlet.
The ON/OFF button (A) is not pressed.
Vacuum/ Seal time is not long enough.
The opening of the vacuum bag was
not entirely and properly placed under
the sealing bar (11).
The sealing bar (11) and the inside
vacuum chamber (9) is not clean
enough.
There is some moisture, food parti-
cles or debris on the seal area of the
vacuum bag.
Inside the vacuum bag has food with
sharp points to penetrate the bag and
thus air enters into the vacuum bag.
Some food can release gases also
food can release gases due to food
spoilage.
Possible solution
Make sure the power plug is connect-
ed properly with the electrical power
outlet.
Press ON/OFF button (A) to start the
machine if it cannot start automati-
cally.
Set longer Vacuum/Seal time.
Pack the food in a new bag and place
properly in the chamber so the en-
tire opening can be sealed. Don't use
bags that don't fit the sealing bar.
Wipe the surface of the sealing bar
(11) and inside the vacuum chamber
(9) to keep clean, dry and free of de-
bris.
Wipe the seal area of the vacuum bag
to make sure it is dry and clean.
Cut off the sharp points or cover it be-
fore packing.
Blanch or frozen the food properly
before packaging. Discard the food if
in doubt.
EN
9