Hendi 201428 Mode D'emploi page 6

A. ON/OFF button
Press this button to switch the machine on or off.
B. START button
The machine has an automatic start function
which activates when the lid is closed. If this is
not set use the START button (1).
C. SEAL button
Press the SEAL button to stop the vacuum pro-
cess and start the sealing process.
D. SET button
With the lid (1) open, press the "SET" button to
EN
set the time of the 3 processes (VACUUM TIME,
SEAL TIME and MARINATE).
E. Time adjust button (
Press these buttons to adjust the time for each
process (VACUUM TIME, SEAL TIME and MARI-
NATE).
Accessories
a. Wrench (1x)
b. Screw driver (1x)
c. Empty bottle with nozzle (1x)
Adding and draining vacuum pump oil
Add oil to the pump if the following situations occur.
Important! Make sure the pump oil is above OIL
LEVEL marking and check regularly.
1. Before first use, the pump needs to be filled with
oil (Supplied).
2. When the oil level is below the OIL LEVEL mark-
ing.
3. When the performance of the machine deteri-
orates.
4. Drain out and re-fill the pump with oil every six
months.
6
Increase / Decrease)
F. Digital display
1) It shows the remaining time of the 3 processes
(VACUUM TIME, SEAL TIME and MARINATE).
2) When the vacuum and sealing process is fin-
ished and the lid (1) is still closed. "CLO" will
be displayed.
G. Light indicator (VACUUM TIME / SEAL TIME /
MARINATE)
1) With the lid (1) open, the indicator will light up
blue, press the
the corresponding process.
2) During each of the process, the corresponding
light indicator is ON to show which part of the
process is active.
H. Vacuum gauge
It shows the pressure level inside the vacuum
chamber.
d. A bottle of pump oil (Volume: 230ml) (1x)
Note: Vacuum bag is not included.
A) Adding oil procedures
• Use the screw driver (supplied) to loosen the
screws (8) of the rear cover (6), remove the cover
to expose the pump.
• Twist off the screw cap anti-clockwise using a
tool (not included).
• Add pump oil using the oil bottle (supplied) until
the oil level is above the OIL LEVEL marking.
• Tighten the screw cap clockwise using a tool (not
included).
or to adjust the time of