Sony SU-WL850 Informations D'installation page 8

5
Install on the wall using
WM1
suitable screws (not supplied)
and washers (not supplied).
× 2
8 mm × 60 mm
Note
 Use a level to check whether
Precaution
 Do not over-tighten wooden screw 8 mm × 60 mm.
Improper tightening could reduce the holding
power of wooden screw 8 mm × 60 mm.
6
Drill lower pilot holes on the
marks. (Refer step 4 for the drill
instruction.)
7
Fit the suitable screws and
washers to the holes.
Note
 Use a level to check whether
WM1
WM1
is level.
× 2
WM1
× 2
WM1
is level.
− 8 (GB) −
8
Pull out the arm of the bracket to
the end.
Preparing for the Installation
of the TV or LCD Monitor
Note
 Be sure to store the removed screws and unused parts
in a safe place, keeping them away from children.
1
Attach the Table-Top Stand to
make the TV or LCD Monitor
standing.
• Refer to your TV's or LCD Monitor's Setup
Guide.
2
Remove the screws from the rear
of the TV or LCD Monitor.