Preparing The Appliance - Ghibli & Wirbel Power Extra 11 Utilisation Et Entretien

PREPARING THE
APPLIANCE
Assembling the hoses
- Insert, as far as possible, the sleeve (1
Fig. 1) of the suction hose into the nozzle
(2 Fig. 1) on the drum.
- To release the sleeve (1 Fig. 2) turn the
lever (3 Fig. 2) clockwise and then pull
the sleeve outwards (1 Fig. 2).
- Connect the (4 Fig. 3) detergent delivery
hose to the quick coupling (5 Fig. 3); to
release it push the quick coupling (5 Fig.
3) inwards.
- Check that the detergent suction tube (6
Fig. 4) is properly connected to the cylin-
der head (7 Fig. 4) and the tank (7a Fig.
4) using the special quick couplings.
Rigid pipe assembly for washing car-
pets or floors (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
- Remove the hose from its stiff as follows:
- Top Tube (8 Fig. 5).
- Lower Hose (9 Fig. 5) complete with
pipe cleaner and nozzle.
- Nozzle for carpets and floor coverings
(10 Fig. 5).
- Hook the two rigid extensions (8 and 9
Fig. 6), matching the two references (11
Fig. 6).
- Connect the hose (12 Fig. 7) coming from
the nozzle quick connector (13 Fig.7) of
the dispenser lever; push the lever.to re-
lease, the quick connector (13 Fig.7).
- Insert the floor nozzle (10 Fig. 8) into the
tube (9 Fig. 8).
- Placethe nozzle (14 Fig. 9) on the mouth-
piece (10 Fig. 9) hooking it into the ap-
propriate bumps in the nozzle (10 Fig. 9).
- Insert the tube (8 Fig. 10) in the hose (15
Fig. 10)
- Connect the quick connector (16 Fig. 11)
of the supply pipe to the fitting (17 Fig.
11) of the dispensing; to release the quick
connector (16 Fig. 11) push lever to the
outside of the tube.
Professional hose assembly for fab-
ric washing (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
- Insert the fabric nozzle (18 Fig.12) into
the flexible hose (15 Fig.12).
- Connect the detergent hose (19 Fig.12)
to the quick coupling (16 Fig.12) on the
flexible hose; to release it push the quick
coupling (16 Fig.12) towards the hose.
Filling the detergent tank
- Pour in the load nozzle (20 Fig. 13) the
liquid detergent suitable for the surface
to be cleaned up to the maximum level
indicated by the red ball positioned inside
the transparent tube (20a Fig. 13).
NOTA:
During the washing operations control the
level of the detergent through the level indi-
cator (20a Fig. 13) and if necessary, restore
the level as indicated above.
NOTE:
For detergent dosing refer to the manufac-
turer's instructions.
Checking the position of the filters
- Release the lever (40 Fig. 13a) and lift
the head (7 Fig. 13b) by checking that
there is a filter (41 Fig. 13b).
- Replace the head (7 Fig. 13b) and hook
the lever (40 Fig. 13a).
EN - 2
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968