probst FTZ-BB Instructions D'emploi page 41

Adjustments
5 Adjustments
5.1 Adjustment of the gripping range
Before the product can be lifted and transported, the gripping range has to be adjusted to the dimensions
of the product.
Otherwise it is not guaranteed that the clamping force is enough to securely grip the item to be gripped
and the item to be gripped could slip off!
•
The adjustment of the gripping range may never take place on both sides at the same time.
Always adjust the gripping range first to the one and then on the other side.
•
Lift the device approx. 0.5 m. Gripping arms must be locked and open (automatic changing device in
position "empty").
•
Pull the spring bolt upwards, rotate around 180° and lock in position (in nick).
•
Move the rectangular tube, until the gripping range is approx. 5 cm larger than the product.
•
Pull the spring bolt back up again and rotate around 180°.
•
Move the rectangular tube so long until the spring bolt engages in one of the holes.
The adjustment of the gripping range must follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular tubes.
Caution while adjusting of the gripping range.
There is a danger of injuring the hands! → Use safety gloves.
Rectangular tube
53100202
Spring bolt
Spring bolt
13 / 20
Rectangular tube
Top view from down
GB