Installation Hints - dosatron Industry Line D8 Manuel D'utilisation

INSTALLATION HINTS

The DOSATRON can be connected to
the main water line directly (Fig. 4), on
a by-pass (Fig. 5).
If your flow rate is above the operating
limits of the DOSATRON, see §
EXCESSIVE FLOW.
To prolong the working life of the
DOSATRON it is advisable to install
a filter (ex.: 300 mesh - 60 microns
depending on your water quality)
upstream.
This is imperative if the water contains
impurities or particles, especially if the
water comes from a well.
Valve
Filter
Fig. 4
EXCESSIVE FLOW (as an indication)
If your DOSATRON clicks more than 40 times in 15 seconds (meaning 20
cycles), you are close to the maximum flow limit. If you need more flow, you
must install a DOSATRON with a superior capacity of flow.
A filter is recommended and required
for the warranty to be valid.
Installing the DOSATRON on a bypass
enables clean water to be supplied
without operating the DOSATRON and
the DOSATRONto be easily removed
for maintenance.
©
DOSATRON INTERNATIONAL S.A.S / 48
When connecting an
installation to the public water
supply, you must respect the
rules and regulations in force
in the country.
Valve
Filter
Check
Valve
Fig. 5