Philips SmartSleep Manuel D'utilisation page 14

SmartSleep - Headband Controls
Short press (1 second): Turns on the device or "wakes" it during a sleep session.
Extended press (3 seconds): Turns off the device.
Factory Reset: A factory reset will delete all existing data. With the USB cable
and charger connected, press and hold the power button for 15 seconds.
The indicator light will begin to flash green indicating the factory reset has
completed.
Audio and Visual Device Indicators
Charging Indicators
When the headband is connected to the USB cable and charger, and the charger is
plugged into a wall outlet, the headband will display one of the following indicators:
Indicator Light
Pulsing orange
Double pulsing orange
Rapid flashing orange
Solid green
Light is off while
headband is plugged in
To check the power status of the headband when it is not connected to the USB cable
and charger, press the power button for 1 second. The headband will display one of the
following indicators during the button press:
Indicator Light
Solid orange
Solid green
Double pulsing orange
Battery status can also be checked while the headband is turned on using the mobile
app by opening the "Control" tab, pressing "My SmartSleep", and viewing the Battery
level.
Headband Connection Indicators
To check the status of the headband connection to the sensors while wearing the
headband, press and release the power button. The headband will display one of the
following indicators:
Indicator Light Audio
Solid orange
Solid green
14
Meaning
Headband is charging.
Headband battery is below the critical battery level. Continue
charging. Syncing cannot occur at this time.
Headband is connected to an unapproved charger. Use the
charger supplied with your device.
Headband is fully charged.
Headband has been fully charged for at least 30 minutes and
has gone into "power-save mode."
Meaning
Battery is not fully charged.
Battery is fully charged.
Headband battery is below the critical battery level. Charge
immediately. Syncing cannot occur at this time.
Continuous beeping
Beeping stops
Meaning
Sensors are not making contact.
Sensors are making contact.