Festool CARVEX PSC 420 EB Notice D'utilisation D'origine page 18

English
ADT-PS 400
Attention: Only use with
materials thinner than
20mm and cross-set sawblade!
Installing the base adapter
► Remove the saw table [1-11] (see section
9.4 ).
► Position the base adapter [9-1] against the
saw table support.
► Close the lever [1-9].
Ensure that the base adapter is firmly seated in
the guide.
Also use the extractor connector [1-8]
with the base adapter.
Adaptation to the FS 2 guide rail
The FS 2 Festool guide system (Fig. [10])
makes it much easier to produce straight and
precise cuts.
► Place the jigsaw with attached base adapter
[9-1] on the guide rail.
Adaptation to the core maker
The core maker can be used to create circular
cuts with a diameter between 4-3/4" and
18
118-1/8" (120 and 3000 mm). The core maker
9
can be installed from both sides on the base
adapter.
► Place the jigsaw with attached base adapter
on the adapter [11-1] on the core maker.
► Insert the centring mandrel [11-2] in the
hole [11-4] on the core maker aligned with
the saw blade.
► Clamp the measuring tape to the core mak­
er using the rotary knob [11-5].
Recommended settings when using the core
maker:
9-1 ► Cut in an anticlockwise direction.
► Work at a slow rate of advance.
► Set the pendulum stroke [1-12] to 0–1.
► Set the stroke rate [1-6] to 1–5.
Store the centring mandrel in the depot
[11-3].
KS-PS 400
11-1
10
12.5 SYSTAINER
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
To lock the Systainer
11-5 11-4
Turn the T-loc [SYS-b-1] to this posi­
tion.
Turn the T-loc [SYS-b-1] to this posi­
tion.
11
11-2
11-3