Working With The Electric Power Tool; Acoustic Warning Signals - Festool CARVEX PSC 420 EB Notice D'utilisation D'origine

Automatic load detection is activated in posi­
tion A: The stroke rate drops when idling and is
adjusted to the highest setting when the work­
piece is introduced.
Recommended stroke rate (position of the ad­
justing wheel)
Hard and soft wood, blockboard, ply­
wood, chipboard
Fibreboard
Plastic
Ceramic, aluminium, non-ferrous met­
als
Steel
10 Working with the electric
power tool
CAUTION
Materials which produce a lot of dust
Damage to the machine due to the ingress of
dust, risk of injury
► Do not work overhead.
WARNING
Risk of injury
► With the tool switched off and unplugged,
check for tight fit of the sawblade before
starting to work
► Always apply the pendulum jigsaw to the
workpiece with the sawblade running.
► Wait until the power tool stops completely
until placing it down. The tool can become
entangled and lead to a loss of control of
the power tool.
When working on small or thin workpieces, al­
ways use a stable base.
When working, hold the electric power tool by
the handle and guide it along the desired cut­
ting line. For precise cuts and smooth running,
use two hands to guide the electric power tool.
10.1 Free saw guidance along a scribe mark
The triangular pointer on the splinterguard
[5-1] indicates the cutting line of the saw blade.
This facilitates sawing along a scribe mark.
10.2 Lighting
Stroboscopic light could lead to misjudge­
ment of the saw blade position
Risk of injury
► Ensure the work area is well illuminated.
A
A steady light or stroboscopic light is installed
to illuminate the cutting line:
4–A
Up to approx. 2100 min
3–A
From approx. 2100 min
3–5
light
In the overhead position (+/- 45°), the
2–4
lighting is switched off completely.
If required, you can adjust the lighting:
► Plug in the electric power tool.
► Press both buttons [1-2] simultaneously
and hold for approx. 10 s until a beep
sounds.
► Release both buttons [1-2].
► Press the left button (on the pendulum
stroke side) the specified number of times
to set the desired mode:
Mode Indication dur­
ing configura­
tion
1 Light flashes
2 Light on
3 Light off
► Press the right button to save the setting.

10.3 Acoustic warning signals

Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
WARNING
-1 : Steady light
upwards: Stroboscopic
-1
Behaviour during op­
eration
With stroboscope
(standard)
Steady light without
stroboscope
Light switched off
English
15