Valor LX1 Serie Manuel page 5

Installation
8. Place the HeatShift
canopy on top of the
fi replace and screw
down (14 screws).
9. Complete any venting
installation still re-
quired prior to installing
remaining HeatShift
canopy kit.
Note: Two 45° elbows
(not included) attached
to the top of the fi re-
place as shown will be
required to off set the
vent for vertical venting.
10. Place and attach both
support brackets (identi-
cal) on top of the Heat-
Shift plenum as shown
(3 screws each).
Option 1 - Top Outlet
11. Place the back plate at
planned installation
height (8 screws). This
plate provides separa-
tion from any adjacent
cavity. The top of the
plate must be a mini-
mum of 2-1/2" from the
fi nished ceiling.
12. Place the top enclosure
on top of the back plate
at the planned install
height (8 screws). The
top of the enclosure
must be fl ush with the
top of the back plate, a
minimum of 2-1/2" from
the fi nished ceiling.
13. Place the fl ex liners.
Clamp them at the top
and bottom of each liner
to the collars (4 clamps).
Min. 2-1/2"
clearance
to fi nished
ceiling
5