Valor LX1 Serie Manuel page 7

Installation
WARNING
Pre-insulate and drywall adjacent wall
as necessary (or required by local code).
This will aid drywall finishing and provide
separation between the HeatShift cavity
and the adjacent wall cavity.
Installation
1. Place left hand stud
(not included, cut to full
ceiling height) vertically
and fl at against wall.
Level and attach to stud
behind wall (or provide
secure backing within
wall for attachment).
Screw every foot to
planned height. Suggest-
ed #10 x 3-1/2" general
purpose wood screws,
not included.
2. Fix right stud (not in-
cluded) to stud or solid
backing behind wall. Dis-
tance is 18-7/16" to the
outside of both studs.
You may use the middle
enclosure to check this
distance by temporar-
ily fi tting the enclosure
around the studs.Screw
every foot to planned
height.
3. If not done already, stop
and fi nish electrical and
gas installation while
you have room (see
"Electrical Wiring" and
"Gas Supply" in the LX1
Installer's Manual).
4. A bottom base or ped-
estal is not required
to install this kit. How-
ever, if one is preferred,
install it now and then
continue with remaining
steps.
5. Attached the wall sup-
port bracket to the
fi replace (4 self-drilling
screws).
Full height
to fi nished
ceiling
6. Place fi replace against
the wall (with standoff s
and support bracket
between studs). Remove
carrying handles before
moving the fi replace into
fi nal position.
18-7/16"
7. Square the fi replace to
the wall and screw feet
(4) to the fl oor.
Option 2 - Front Grille
90°
7