Mount Additional Handgrip; Assemble/Set Protective Hood; Installing/Changing Disc; Operation - Parkside PWSA 18 A1 Traduction Des Instructions D'origine

All manuals and user guides at all-guides.com
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device

Mount additional handgrip

The device must only be op-
erated with the handgrip
mounted.
Screw the additional handgrip (2), de-
pending on the type of work, to the left,
right or above the device using the thread-
ing for the handgrip (4).
Assemble/set protective
hood
Adjust the protective cover such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective cover must also be posi-
tioned such that the sparks cannot ignite
combustible parts, including those in the
surroundings.
The device must only be
operated with the protective
hood mounted.
1. Open the tightening lever
(15).
2. Place the protective hood (17)
on the positioning holes.
3. Turn the protective hood (17) into
the working position. The closed
side of the protective hood must
always face the operator.
4. Close the tightening lever
(15) again. The protective hood
should not be able to be turned
any more.
If needed, the tension on the adjustment
nut ( 21) can be set.

Installing/changing disc

1. Press the spindle stop button (3).
2. Release the clamping nut
( 19) with the chuck key
(1).
3. Set the desired disc onto the
mounting flange (
on the disc should always face
the device.
4. Set the clamping nut (
the mounting spindlel (
again. The flat side of the clam-
ping nut must face the attach-
ment tool.
5. Press the spindle stop button (3)
and pull the clamping nut (19)
tight again using the chuck key
(1).

Operation

Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and ac-
cessories recommended by the
manufacturer. Using other attach-
ment tools and other accessories
can represent a risk of injury for
you.
- Only use grinding tools which
bear information about the
manufacturer, type of binding,
dimension and permitted number
of revolutions.
- Only use grinding discs where
the printed rotational speed is at
GB
18). label
19) on
20)
67