Practical Tips; Assembly; Mount Handgrip; Assemble/Set Protective Hood - Parkside PWS 125 B2 Traduction Du Mode D'emploi D'origine

GB

Practical tips

Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel
for cutting !
Only certified, fibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.

Assembly

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device
52
All manuals and user guides at all-guides.com

Mount handgrip

Screw the handgrip (1), depending on the
type of work, to the left, right or above the
device using the threading for the hand-
grip (2/6)..
Assemble/set protective
hood
If needed, the tension on the adjustment
nut (
(

Installing/changing disc

The device must only be
operated with the handgrip
mounted.
The device must only be
operated with the protective
hood mounted.
1. Open the tightening lever
C
( 16)
2. Place the protective hood (
11) on the positioning holes.
3. Turn the protective hood (
11) into the working position.
The closed side of the protective
hood must always face the ope-
rator.
4. Close the tightening lever
C
( 16) again. The protective
hood should not be able to be
turned any more.
C
15) can be set. Use the chuck key
9) for this.
1. Press the spindle stop button
( 7).
2. Release the clamping nut
B
( 13) with the chuck key
( 9).