Mantel Requirements - Valor Madrona MFCS01 Manuel D'installation

Casting Tolerances
Due to the nature of cast iron and concrete, dimen-
sional consistency may vary from one unit to the next
and some variation in surface finish and flat-ness is to
be expected. We have done our best to control and
make allowance for this; however some variation is
inevitable.
Floor Requirements
The Madrona heater is approved for installation directly
on any combustible material other than soft flooring
material such as carpet or vinyl.
Mobile Home Floor Fixing
The Madrona stove must be fixed to the floor through
the floor when used in a mobile home.

Mantel Requirements

The Madrona stove may be installed with a combustible
mantel provided clearances are maintained as indicated
above. Be aware that although safe, some combustible
materials and finishes at the listed clearances may, over
time, discolor, warp, or show cracks. Care should be
taken when choosing materials—consult your fireplace
dealer.
4
Installation
Unpack the appliance and stove casing
The Madrona engine is supplied separately from the
stove casings. The Traditional stove—MFCS01 (black)
or MFCS02 (majolica brown)—are each supplied in two
cartons. You must have in hand the stove casing before
starting the assembly of the appliance.
Unpack the carton carefully. Some parts are packed in
the cardboard sleeve around the engine; make sure
you take them all out of the packaging. Make sure you
have all the components including the stove casing
components before you start the installation.
Caution
LEAVE THE ENGINE ON ITS PACKAGING BASE to
avoid damage to the control valve, wires and
pipes until ready to insert into stove casing.
Tip
• Remove the MF28 window and all items inside the
appliance before installing to lighten it.