Valor Madrona MFCS01 Manuel D'installation page 5

Casting Base
1. Rough-in the gas line and electrical wiring for a fan
(if any).
2. Decide where the stove should be placed to avoid
moving it once all the casting pieces are attached
together.
3. Place the casting base upside down.
a. Unscrew the bolts to insert the legs.
b. Slide each leg under the head of its bolt.
c. Tighten the bolts securely with a wrench.
Detail
b
a
4. Install gas pipe bracket using 1 M6 hex bolt supplied.
If planning to install the optional fan, install the
fan control box bracket on top of the pipe bracket,
securing both brackets with the same bolt.
Gas pipe
bracket
Casting base—underside view
c
Fan control
box bracket
5. Flip the base up.
6. Place the engine on the base at its approximate final
position—see detail below. Center the engine using
the holes at front of the base as guidelines.
Optional Fan
If this installation requires the optional fan, it is easier to
install the fan motor now.
1. Remove the mounting plate from the fan and
discard it.
Detail
Unscrew 3 screws and
remove fan mounting
plate
5