Valor Madrona MFCS01 Manuel D'installation page 7

Top Spar
1. Position the top spar on the side brackets located
between the engine and the cast sides.
2. Secure the spar with two 3/8" pre-assembled screws
provided.
Gas Pipe
1. Connect the gas supply pipe to the gas valve as
shown below. Note that the pipe travels below the
pipe bracket attached to the stove left side.
Optional fan (if installed)
Pipe bracket
Front view
2. Secure the gas pipe with the clamp and screw
provided with the engine's hardware pack.
Pipe bracket
Pipe clamp
Front view
Casting crossbar
(transparent for clarity)
Optional fan (if installed)
Casting crossbar
(transparent for clarity)
Pipe clamp
Detail—viewed
from underside
Complete engine installation
Refer to the engine installation manual for the following
steps.
1. Reposition the lighting instructions plate, remote
control receiver and connect gas line to the inlet
pipe.
2. Convert the top outlet to a rear outlet or co-linear
outlet as necessary.
3. Install venting system.
4. Install the logs.
5. Refit the window and the hot glass warning plate.
6. Set up the remote control and check operation.
Front Installation
Hook the cast front to the side brackets located between
the engine and the cast sides.
Details
Hook
Cast front
Engine
Side bracket
7