Continuity Test - Abus TVAC10100 Manuel Utilisateur

Push the menu button again to open the submenu for the RS485 settings.
Use the ▲▼ buttons to navigate through the menu.
Keep pushing the menu button to open the respective subitem.
Use the ◄► buttons to change the settings for the respective subitem.
Use the menu button to confirm your change.
For correct operation of the speed dome, the settings of the monitor's RS485 interface must match the speed
dome settings.
e.g. Camera ID
Pelco
Baud rate
Controlling the camera:
You can steer the camera with the arrow buttons.
Zooming the camera:
Zoom in:
Zoom out:

7.5. Continuity test

The test monitor enables you to test 2 cables for short circuits. Connect the cables on one side to perform a
continuity test.
Use the MODE button so select the continuity test mode („cable test").
Connect the first cable to the right connector and/or the second cable to the left connector of the terminal
strip.
1
D
4800
Push the ▲ and ► buttons simultaneously
Push the ▼ and ◄ buttons simultaneously.
Cable 2
The measurement result is displayed as follows:
Cable test
OK There is no interruption
NG The cable shows an interruption.
(identification number of the camera)
(Setting the control protocol to Pelco D or P)
(baud rate setting for the control signals)
Cable 1
Cable1 NG
Cable2 NG
28
English