Lenz Digital plus BM2 Mode D'emploi page 34

34 Information BM2
8.2 Push-pull operation
You can also use the BM2 for push-pull operation. Preferably, the BM2 module will be used where
the rear-powered (pushed) train is to stop. In this case, a BM1 module suffices at the opposite
stopping point.
8.3 Using the BM2 at the end of a block section
You can use the BM2 module to complete a block section of BM3 modules. In a typical case, the
entry signal to a station would be at the end of a block section. By setting the entry signal, you, as
the conductor, determine whether an arriving train may or may not enter the station.
Braking Braking
Driving section Driving section
section section
Direction of travel
Block signal Entry
2 2 C
a b signal
1 2 O O C