Conrad SkyRC NC2500 Mode D'emploi page 60

11. Bluetooth Connection (iOS)
a) Pairing
The charger has a wireless Bluetooth interface. To connect to an iPhone, iPad or iPod, proceed
as follows:
• If it has not happened, connect the charger to the enclosed plug-in mains adapter; plug the
plug-in mains adapter into a mains socket.
• Keep the button „ENTER" pushed for about 5 seconds until the Bluetooth-LED (9) starts flashing
slowly.
• Switch on the Bluetooth function in your iPhone, iPad or iPod. This is to be performed in the
settings menu of the respective device.
• After a few seconds, the charger should be available as a new Bluetooth device
(„skyrcXXXX", the four „X" mean a four-digit serial number). Select this new device so that it
is connected to the iPhone/iPad/iPod.
This process may take a few seconds.
• After the Bluetooth connection was established, the Bluetooth LED (9) stops flashing and
remains lit.
b) Pairing with Several Devices
There can only be one Bluetooth connection at a time. It is not possible to access the charger.e.g.
with two or more iPads.
Alternating access is possible, e.g. when you want to read the charge data with an iPad one day
and with an iPhone another day.
The charger can sae the connection data of up to 8 devices so that pairing with each device is
only necessary once. Therefore, proceed as described in chapter 11. a).
When all 8 memories are full, no further device can be registered. Then the internal
pairing memory must be deleted.
Keep both buttons „2" and „8" pushed at once for at least 5 seconds. This deletes
all the present devices from the pairing memory.
Then proceed again as described in chapter 11. a).
60
All manuals and user guides at all-guides.com