Conrad SkyRC NC2500 Mode D'emploi page 57

d) Rechargeable Battery Programme „DISCHARGE"
This rechargeable battery programme serves to discharge a rechargeable battery with
a set discharge current (100 mA to 1000 mA).
After insertion of the rechargeable battery into one of the 4 charging chutes, chose the rechargeable
battery programme „DISCHARGE" with „2" or „8", then push the button „ENTER".
The discharge current now flashes at the top of the display; set it with the button „2" or „8".
After confirmation with „ENTER" (or if no button is pushed for more than 5 seconds), discharging
commences.
During discharging, the display alternatingly shows the rechargeable battery voltage in volt
(„DisCharge Volt"), the discharging current in mA („DisChargeRate"), the elapsed discharge
duration in hours/minutes („DisCharge Time") and the discharged energy/charge capacity in
mAh („DisCharge Capacity").
After the end of discharging, „DONE" appears in the display. The discharge
capacity (in the figure on the right: 2193 mAh), the discharging duration and
cell voltage are displayed alternatingly.
The rechargeable battery can now be taken from the charger.
A rechargeable battery should not be stored in the discharged
condition since there may otherwise be deep discharge, which
will permanently damage the rechargeable battery.
All manuals and user guides at all-guides.com
57