weewell WMA440 Mode D'emploi page 6

6
2. Remove the battery compartment cover and insert the 2 x
AArechargeable batteries into the battery compartment on
theParent unit and replace the battery compartment cover
asshown. You should always ensure you have inserted batteriesin
the Parent unit.
3. Slot the Parent unit into the charger, the red charging
lightcomes on. Charge the batteries for 16 hours before
switchingon the Parent unit.
Note: if you ever need toremove the batteries, remove thebattery compartment cover
and tip the parent unit until theyslide out.
IMPORTANT
Your WMA440 Baby Monitor is designed
to be an aid and should not be used as
a substitute for responsible and proper
adult supervision.
Make sure the Baby unit, Parent unit
and mains adapter cable are kept out
of reach of your baby – at least one
metre away.
Never place the Baby unit inside your
baby's cot, bed or playpen.
Never cover your Parent or Baby units
(e.g. with clothes, towels or blankets).
Never use or place your Parent or Baby
units in moist places or near water.
If travelling abroad, make sure that the
voltage shown on the mains power
adapter corresponds to the local mains
power before connecting to the power
supply.
There is a risk of explosion if the batteries
are replaced by an incorrect type.
Dispose of used batteries according to
the instructions.
Always dispose of batteries in
accordance with applicable waste
disposal regulations, never in your
household rubbish.
Battery performance - Parent unit
Rechargeable batteries in the
Parent unit give up to 14 hours
continuous performance.
Please note however, that new
batteries do not reach full capacity
until they have been in normal use for
several days.