Help; Helpline - weewell WMA440 Mode D'emploi

24

HELP

Helpline

If you have any problems using your WMA440 Baby Monitor,
please visit www.weewell.com
Link light does not come on
• Check that both the Baby and Parent units are switched on.
• If using batteries check that they are correctly installed and that
they are not drained.
Link light is flashing green
• If you have pressed to use the Talk Back feature, the link light
will flash to indicate one - way communication between the units.
• The units are searching for a communication link.
• Check they are within range of one another and that the mains
power (or batteries) are properly connected.
Link light is red
• The link between your Units is broken. You will also hear an
alert to let you know there is no communication between the
Units. If this happens, check that the mains power (or batteries)
is correctly connected and that the Units are within range of one
another.
Parent unit remains silent or very quiet
• The sensitivity setting may be too low, see page 19.
• You may have set the volume too low, see page 15.
You can hear a high pitched noise
• The Units are too close to each other, or the volume setting is
too high.
Talk back feature is not working
• Check that the volume is loud enough at the Baby unit, see page
15.