Abicor Binzel ADF 600S Mode D'emploi page 37

ADF 600S
Fault Cause
The welding • The head band was not adjusted evenly.
helmet slips.
Tab. 11 Troubleshooting
11 Disassembly
NOTICE
• Disassembly must only be carried out by qualified personnel (in Germany, see TRBS 1203).
• Observe the information provided in the following section:
Disassemble the ADF 600S as follows:
 9.2 Replacing the automatic filter on page EN-17
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. To correctly dispose of the product, it must first be disassembled.
 11 Disassembly on page EN-19
12.1 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
All manuals and user guides at all-guides.com
 8 Putting out of operation on page EN-15
Troubleshooting
• Adjust the head band precisely and ensure equal
distance of the eyes to the filter lens.
 6.2 Adjusting head band on page EN-10
 6.3 Adjusting head circumference on page EN-10
11 Disassembly
EN - 19