Protective Clothing - Güde GPS-E 40AK Traduction Du Mode D'emploi D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
ENGLISH
in small rooms with electrically conductive walls
26
(boilers, pipes etc.), in hot rooms (sweat-soaked work
clothes), the output voltage of the plasma cutter may
not exceed 48 V~ in idling conditions (effective value).
The device may thus be operated in this case on the
basis of its output voltage in idling conditions.
When working in small or hot rooms, insulating bases
and interim layers, as well as gauntlets made from
leather or other non-conductive materials, are to be
used to insulate the body against the floor, walls,
conductive parts of the device and similar.

Protective clothing

Caution! Risk of accident due to spraying
sparks
The spraying cutting sparks may lead to painful
burn injuries.
Therefore, always observe the following instruc-
tions:
• Always wear a leather apron.
• Use leather gloves.
• Wear suitable head protection when cutting
overhead.
• Ensure that your trouser legs cover the tops of
your shoes.
• Wear sturdy, insulating footwear.
Whilst working, the welder's entire body must be
protected against radiation and burns by means of
the clothing and face protection.
Gauntlets made from a suitable material (leather)
must be worn on both hands. These must not be
damaged. Special welding gloves to be worn at all
times. Suitable aprons must be worn to protect the
clothing against flying sparks and burns. If the nature
of the work, e.g. overhead welding, requires this, a
protective suit must worn and, where necessary, this
must also include suitable head protection.
The protective clothing which is used, as well as all
the accessories, must be compliant with the "Per-
sonal Protective Equipment" Directive (2016/425).
SYMBOLS
WARNING/CAUTION!
Ground before use
WARNING
tions to reduce the risk of injury.
Use a welding mask!
-
Read the operating instruc-
Special welding gloves to be worn at all
times.
Wear safety cut through resistant shoes
with safety sole and steel toe !
Protective apron to be used
Unplug the machine before any work
on it.
Wear dust mask
Warning against toxic fumes!
Warning against hot surfaces!
Warning against dangerous voltage
The appliance must be stored in a dry place and
protected from frost.
Keep the machine out of reach of children.
Never expose tool to rain.
Single Phase Output
Static Frequency Converter
Rectifier
Plasma arc cutting
Suitable for welding with an increased
electric risk.
Single-phase alternating current with
rated frequency of 50-60 Hz
Direct Current
Fan
Keep dry at all times.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

20096

Table des Matières