Protective Clothing - Güde GPS E 40 A 2 Traduction Du Mode D'emploi D'origine

ENGLISH
24
basis of its output voltage in idling conditions.
When working in small or hot rooms, insulating bases
and interim layers, as well as gauntlets made from
leather or other non-conductive materials, are to be
used to insulate the body against the floor, walls,
conductive parts of the device and similar.

Protective clothing

Caution! Risk of accident due to spraying
sparks
The spraying cutting sparks may lead to painful
burn injuries.
Therefore, always observe the following instruc-
tions:
• Always wear a leather apron.
• Use leather gloves.
• Wear suitable head protection when cutting
overhead.
• Ensure that your trouser legs cover the tops of
your shoes.
• Wear sturdy, insulating footwear.
Whilst working, the welder's entire body must be
protected against radiation and burns by means of
the clothing and face protection.
Gauntlets made from a suitable material (leather)
must be worn on both hands. These must not be
damaged.
Special welding gloves to be worn at all times.
Suitable aprons must be worn to protect the clothing
against flying sparks and burns. If the nature of the
work, e.g. overhead welding, requires this, a protec-
tive suit must worn and, where necessary, this must
also include suitable head protection.
The protective clothing which is used, as well as all
the accessories, must be compliant with the "Per-
sonal Protective Equipment" Directive (2016/425).
SYMBOLS
WARNING/CAUTION!
Ground before use
WARNING
tions to reduce the risk of injury.
Use a welding mask!
- Read the operating instruc-
Special welding gloves to be worn at all
times.
Wear safety cut through resistant shoes
with safety sole and steel toe !
Protective apron to be used
Unplug the machine before any work
on it.
Wear dust mask
Warning against toxic fumes!
Warning against hot surfaces!
Warning against dangerous voltage
The appliance must be stored in a dry place and
protected from frost.
Keep the machine out of reach of children.
Never expose tool to rain.
Single Phase Output
Static Frequency Converter
Rectifier
Plasma arc cutting
Suitable for welding with an increased
electric risk.
Single-phase alternating current with
rated frequency of 50-60 Hz
Direct Current
Fan