Festool OFK 500 Q Mode D'emploi page 7

5 Working with the machine
Always secure the workpiece in such a
manner that it cannot move while being
sawed.
Set the required milling depth and steadily
guide the machine along the edge of the work-
piece, ensuring that the guiding table and the
milling tool ball bearing are in contact with the
workpiece at all times.
6 Maintenance and care
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
Always keep the machine and the ventilation
slots clean.
All maintenance and repair work which requires
the motor casing to be opened may only be
carried out by an authorised service centre.
7 Accessories, tools
The accessory and tool order number can be
found in the Festool catalogue or on the Internet
under "www.festool.com".
All manuals and user guides at all-guides.com
7
8 Warranty
Our equipment is under warranty for at least 12
months with regard to material or production
faults in accordance with national legislation.
In the EU countries, the warranty period is 24
months (an invoice or delivery note is required
as proof of purchase).
D a m a g e r e s u l t i n g f r o m , i n p a r t i c u l a r,
normal wear and tear, overloading, improper
handling, or caused by the user or other da-
mage caused by not following the operating
instructions, or any fault acknowledged at the
time of purchase, is not covered by the war-
ranty.
Complaints will only be acknowledged if the
equipment has not been dismantled before
being sent back to the suppliers or to an autho-
rised Festool customer support workshop.
Store the operating instructions, safety notes,
spare parts list and proof of purchase in a safe
place.
In addition, the manufacturer's current warran-
ty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as
a result of ongoing research and development
work.