Adjusting The Balance; Preparing The Fuel - Shindaiwa M2510 Manuel D'utilisation

Before you start
1. Press latch

Adjusting the balance

Adjusting the shoulder harness
1. Shoulder harness
1. Emergency tab

Preparing the fuel

Fuel is highly inflammable and there is a risk of fire if it is handled incorrectly. Carefully read
and observe the precautions in the section of this manual titled "For safe use of your prod-
uct".
Once the refuelling is complete, securely tighten the fuel tank cap and do not forget to
check that there are no leaks or discharges of fuel from the fuel pipe, fuel system grommets,
or around the fuel tank cap. If you do find fuel leaks or discharges, stop using the product
immediately and contact your dealer to have it repaired.
If the fuel ignites, it could cause burns and fire.
There is difference in pressure between the fuel tank and the outside air. When refuelling, loosen the fuel tank cap
slightly to eliminate the difference in pressure.
Otherwise, fuel may get spewed.
Removing a tool attachment
1. With the unit on a clean, flat surface, loosen the coupler
screw. The spring-loaded coupler protector should pop up.
2. Press down on the latch with your finger or thumb. This re-
leases the coupler lock.
3. Pull the tool assembly out of the coupler.
1. Hook the harness hook to the hanger on the outer tube.
2. Wear the shoulder harness so that the hook stays at your
right hand side.
3. Adjust the length of the shoulder harness so that you can
hold and operate the machine comfortably.
The shoulder harness is fitted with an emergency release
function. In case of emergency, strongly pull the emergency
tab at the hook. The machine will be released from the strap.
DANGER
CAUTION
14