Handling The Product; Precautions For Use - Shindaiwa M2510 Manuel D'utilisation

For safe use of your product

Handling the product

General precautions
Operator's manual
Be careful to read the operator's manual properly before using your product in order to ensure correct
operation.
Failure to do so could lead to an accident or serious injury.
Do not use the product for anything other than its intended purpose
You must not use the product for any purpose other than those described in the operator's manual.
To do so could lead to an accident or serious injury.
Do not modify the product
You must not modify the product.
To do so could lead to an accident or serious injury. Any malfunction resulting from a modification to the product will not be
covered by the manufacturer's warranty.
Do not use the product unless it has been checked and maintained
You must not use the product unless it has been checked and maintained. Always ensure that the product is checked
and maintained on a regular basis.
Failure to do so could lead to an accident or serious injury.
Loaning or assigning your product
When loaning your product to another party, ensure that the person borrowing the product receives the operator's
manual along with it.
If you assign your product to another party, please enclose the operator's manual with the product when handing it
over.
Failure to do so could lead to an accident or serious injury.
Being prepared in case of an injury
In the unlikely event of an accident or injury, please ensure that you are pre-
pared.
First aid kit
Towels and wipes (to stop any bleeding)
Whistle or mobile phone (for calling outside help)
If you are unable to perform first aid or call for outside help, the injury could
worsen.

Precautions for use

The area within a 15 m radius is a danger zone
The area within a 15 m radius of the product is a danger zone. Be careful to observe
the following precautions while working with the product.
Do not allow children and other people or pets to enter the danger zone.
If another person enters the danger zone, turn off the engine to stop the cutting
attachment from rotating
When approaching the operator, signal to him by, for example, throwing twigs
from outside the danger zone, and then check that engine has been switched off
and the cutting attachment has stopped turning
If more than one person is working with the product, identify the way in which
you will signal to each other and work at least 15 m apart
Any objects that ricochet off the cutting attachment, and any contact with the cutting attachment, could cause blindness or a
fatal accident.
WARNING
DANGER
8