Speck pumpen BADU 90/40 Eco MV-E Fiche Technique page 36

Reset
If the buttons "Exit", "Run/Stop" and the arrow button "left" are pressed
1
simultaneously for a minimum of 2 seconds, the unit will be
reset to the factory settings.
Digital control box BADU
®
with BADU EasyTronic
The control box is intended to integrate a backwash unit (BADU
filter pump.
Additional digital inputs can be used for the external control of speeds.
Voltage is supplied using the pump's RS485 data cable.
The digital inputs "1-1", "2-2", "3-3" and "4-4" may only be wired with
potential free contacts.
Connect the RS485 data cable plug to the pump.

Wire the free strands to the terminals "rd" (red), "bk" (black),

"ye" (yellow) and "gr" (green).
Connection diagram for BADU

A1
Control:
Mains
+
--
-X1
Fuse protection required
on site in accordance
with EN 60204-1
M-1
br
bl
Mains
gnge
Pump
1~ / N/PE AC -- 230V / 50Hz
36 EN VG 766.2100.060
®
90/40 Eco MV-E – Connection
Signal
M 4
+
--
M
1
2,2 kW
®
EasyTronic as follows:
M 3 M 2 M 1
+ + +
-- -- --
02/6/-X2:2
02/4/-K2:18
02/2/-K1:12
®
EasyTronic) into the
02/7/-X2:1
06/2014
02/1/-K1:11
+
--
02/1/