Speck pumpen BADU 90/40 Eco MV-E Fiche Technique page 35

The priming protection cannot be deactivated in any other operation mode
Setting the key lock
1 To activate or deactivate the
keypad lock, press and hold the
"Enter" and "Exit" buttons together
for approx. 2 seconds.
2 Pressing the "Enter" button will
then activate or deactivate the
keypad lock.
When the keypad lock is activated,
the pump can still be started or
stopped via the "RUN / STOP"
button.
It is optionally possible to control the four "Customer Flow" programs
externally via the RS-485 interface using a digital control box which is
available for purchase separately. The "Custom Flow" programs can be
controlled using this additional control box, independent of the set time.
Following a power cut, the same mode as that used before the loss of power
(RUN or STOP) is maintained. In the RUN mode the pump is restarted at the
same speed.
06/2014 VG 766.2100.060
optional
EN 35