Speck pumpen BADU 90/40 Eco MV-E Fiche Technique page 26

EN
User interface BADU
(1) RUN / STOP button. Used to start and stop the day/time programs. The button
lights up green when the program run is activated. It goes off when the motor
switches to stand-by mode. This button does not disconnect the unit from the
mains!
(2) Selections are confirmed and saved by pressing the Enter button. The arrow
buttons are used to change the values. If a motor program is running, the
volumetric flow is increased or decreased in steps of 5% by pressing the arrow
buttons.
(3) The Run MAX Flow / Vacuum button is for cleaning, bottom vacuuming and other
skimming purposes. The program is run using the Enter button.
(4) Press the Run Custom Flow button to select a preset timer program. Programs
are started with the Enter button.
(5) The Program Menu button can be used to set the day of the week, switch on/off
times and flow rate.
(6) The Exit button is used to exit the programming menu or cancel a program without
saving changes.
06/2014 VG 766.2100.060
®
90/40 Eco MV-E
EN 26