For Your Safety; Intended Use - MIRKA PS 1437 Notice D'instruction D'origine

Polisher PS 1437

For your safety

WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or
serious injuries. Save all warnings and
instructions for future reference.
Before using the polisher, please read and
follow:
these operating instructions,
–
the "General safety instructions" on the
–
handling of power tools in the enclosed
booklet,
the currently valid site rules and the
–
regulations for the prevention of
accidents.
This polisher is state-of-the-art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged. The polisher
may be used only
as intended,
–
in perfect working order.
–
Faults which impair safety must be repaired
immediately.

Intended use

This polisher is designed
– for commercial use in industry and trade,
– for all types of polishing work with
polishing sponges, lambskins and
woolskins, felt plate, buffing disc
– for use with polishing tools which are
permitted to run at a speed of at least
3700 r.p.m.
Safety instructions for polishing
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or
serious injuries. Save all warnings and
instructions for future reference.
 This power tool is intended to function as
a polisher. Read all safety warnings,
instructions, illustrations and specifi-
cations provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.
 Operations such as grinding, sanding,
wire brushing or cutting-off are not
recom-mended to be performed with this
power tool. Operations for which the
power tool was not designed may create a
hazard and cause personal injury.
 Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because
the accessory can be attached to your
power tool, it does not assure safe
operation.
 The rated speed of the accessory must
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
 The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot
be adequately guarded or controlled.
 Threaded mounting of accessories
must match the grinder spindle thread.
For accessories mounted by flanges,
the arbour hole of the accessory must
fit the locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.
 Do not use a damaged accessory.
Before each use inspect the accessory
such as abrasive wheels for chips and
cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or
cracked wires. If power tool or accessory
is dropped, inspect for damage or install
an undamaged accessory. After
inspecting and installing an accessory,
position yourself and bystanders away
from the plane of the rotating accessory
and run the power tool at maximum no-
load speed for one minute. Damaged
accessories will normally break apart
during this test time.
55