Safety Instructions - Okay RT 2110 D Mode D'emploi

4. Safety instructions

Attention: Using electric power tools, you must
observe following fundamental safety instructions to
protect yourself.
Read all these instructions before using the grass trim-
mer and observe them. Keep these safety instructions
at a safe place.
1) Instructions regarding to safe handling
a) Wear goggles or properly fitted safety glasses,
sturdy closed shoes with non-slip soles, gloves,
snug-fitting work clothes and ear protectors (ear
plugs or ear mufflers).
b) Minors should never be allowed to use an electric
trimmer. Never lend or rent your electric trimmer
without these operating instructions.
c) Do not use the trimmer if other persons, above all
children, or animals are near the working area.
d) Work calmly and stay alert. Operate the trimmer
under good visibility and daylight conditions only.
e) Before using the machine, the line and extension
cords have to be checked for signs of damage or
ageing. Do not use the trimmer when the cords
are damaged or worn.
f) Do not use damaged power supply cords, exten-
sion cords, couplings, plugs or cutting heads.
g) Careless use can cause injuries to hand and feet
by the rotating cutting elements. Do not switch on
the unit when hands or feet are near the cutting
elements.
h) Warning ! Danger of injury by the line cutting
device. After replacing a spool or lengthening the
cutting line, be sure to bring the unit onto normal
working position before turning it on again.
i) Never use metal cutting devices.
j) Only use original spare parts.
k) Always switch off the trimmer and disconnect the
plug from the power supply before carrying out
any maintenance or repair work on the unit.The
device must always be switched off and the plug
removed from the socket before all adjustments
or cleaning, or before the connection is checked
for creases or damage.
l) Inspect cooling air slots on the motor housing at
regular intervals for clog-ups and clean as neces-
sary.
2) Maintenance
a) Always switch off your trimmer and disconnect it
from the power supply before taking a break and
after finishing work. Do not forget maintenance.
(Plug disconnected!) Only carry out maintenance
and repairs described in these operating instruc-
tions.
b) Children should be under supervision to ensure
that they do not play with the device.
c) Any other work should be performed by your
dealer.
d) Never use metal cutting devices.
e) Clean the cutting head at regular intervals.
f) Check the condition of the cutting head at fre-
GB | Operating Instructions
3) General Instructions
1. Read the instructions manual
2. Have your dealer or a specialist show you how to
3. Before using the machine, the line and extension
4. If the cord is damaged during utilisation, it must
5. Do not use damaged power supply cords, extension
6. Attention! Danger. The cutting head continues to
7. Hold the extension cord so that it is always away
8. For a safe operation, it is recommended to supply the
9. Before starting work check that your electric trimmer
10. Attention: The mains connection line of this device
11. Only use extension cords that are approved for
12. Never tug the extension cord to disconnect the plug.
13. Arrange the extension cord so that it cannot be dam-
14. Be careful not to chafe the extension cord on cor-
GB-3
quent intervals. If the behaviour of the cutting
head changes (vibration, noise), check immedi-
ately as follows: Switch off the trimmer, hold it
firmly and bring the cutting head to a standstill by
pressing it against the ground. Then disconnect
plug from power supply. Check condition of cut-
ting head - look for cracks.
g) Have a damaged cutting head replaced imme-
diately - even if it only has superficial cracks.
Never attempt to repair a damaged cutting head.
h) Inspect cooling air slots on the motor housing at
regular intervals for clog-ups and clean as neces-
sary.
i) Clean plastic parts with a damp cloth. Do not use
aggressive cleaning chemicals.
j) Never hose down the electric trimmer!
k) Store trimmer indoors in a dry, high or locked
place and always keep out of reach of children.
operate your trimmer.
cords have to be checked for signs of damage or
ageing. Do not use the trimmer when the cords are
damaged or worn.
be disconnected immediately from the mains. DO
NOT TOUCH THE CORD BEFORE IT IS DISCON-
NECTED FROM THE MAINS.
cords, couplings, plugs or cutting heads.
rotate after switch-off (flywheel effect). Keep your
fingers and feet well clear to avoid injury.
from the rotating nylon line.
machine over a fault current safety breaker (RCD)
with a fault current not over 30 mA. Contact an elec-
trician for further information.
is in good condition and that it is operating properly.
Pay special attention to the power supply cord, ex-
tension cord, power outlet, switch and cutting head.
must be replaced by the manufacturer's technical
service personnel or a qualified electrician only!
outdoor use and that are not lighter than rubber tube
cords type H07 RN-F according to DIN/VDE 0282
with a diameter of at least 1.5 mm
plugs must be splashwater-proof. Never operate
your trimmer without a properly mounted and se-
cured safety cover. Check tightness of cutting head.
Always grip the plug.
aged and does not cause a hindrance.
ners, pointed or sharp objects. Do not squeeze
. Couplings and
2