EUROM Q-Tower 2000 RCD Mode D'emploi page 16

Installation
WARNING
Do not use an extension cable, this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2000 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Place the device on a level and steady
surface.
2. Place the device with a minimum distance of
1.5 meter to any object, wall or ceiling.
3. Do not place the device immediately below a
socket outlet.
4. Make sure the ON/OFF switch is in the OFF
position (Figure 8, pos. 1).
5. Put the power plug into an earthed wall
socket that is easily accessible. Use an
earthed wall socket with a minimum power of
2000 Watt.
Remote control
1. Pull the lip (Figure 9, pos. 1) and remove the
cover (Figure 9).
2. Remove the batteries (if present).
3. Insert two batteries (AAA 1.5 V) as indicated
in the battery compartment. Make sure to
insert the batteries correctly (Figure 9, pos.
2).
4. Replace the cover.
16
Figure 8
Figure 9