EUROM Q-Tower 2000 RCD Mode D'emploi page 15

Assembly
1. Lay the main body down on a steady surface (Figure 6, pos. 7).
2. Pull the power plug (Figure 6, pos. 4) through the center opening of the base cover
(Figure 6, pos. 6) and the base (Figure 6, pos. 5).
3. Bring the main body, the base cover and the base together.
4. Place the washers (Figure 6, pos. 1) and fix the Allen screws (Figure 6, pos. 2) with the
included Allen key.
Figure 6
5. Place the power cable through the cable slot (Figure 7).
6. Put the cover plate (Figure 7, pos. 1) over the cable slot and fix it onto the base with the
screws (Figure 7, pos. 2) and a Phillips screwdriver (Figure 7, pos. 3).
Figure 7
15