Useful Information; Cleaning And Care; Important - VALBERG WF 914 B S180C Consignes D'utilisation

B
Using the appliance
Draining the waste water (depending on the model)
• Before draining the waste water, switch off and unplug the appliance from the mains.
Remove the pump cover and place a container underneath.
1. Pull the emergency drain hose from the machine.
2. Place the end of the emergency drain hose in a container.
3. Unscrew the emergency drain hose cap and remove it once it has been loosened.
4. Wait until the water flows naturally.
5. Refit the emergency drain hose cap.
6. Fill the dispenser drawer with 1 L of water to check the emergency drain hose. Check that
there is no leakage at the connection of the hose cap.
7. Put the emergency drain hose back in its storage position.
34 EN
C

Useful information

Cleaning and care

Outside of the appliance and control panel
• Can be cleaned with a soft damp cloth.
• A small amount of detergent (non-abrasive) can also be used.
• Dry with a soft cloth.
Door seal
• Clean with a damp cloth if necessary.
• Regularly check the condition of the door seal.
Dispenser drawer
1. Lower the lever that releases the main wash compartment and remove the drawer (fig. B).
2. Remove the siphon from the softener compartment (fig. C).
3. Clean all the parts with clean water.
4. Put the siphon back in the dispenser drawer and put the drawer back in its housing.
Fig. B
Lint filter
• We recommend that you check and clean the filter regularly (at least two to three times a
year). This should be done more frequently in the following cases:
1. If the washing machine does not drain the waste water properly or if it cannot perform
the spin cycles.
2. If the pump is blocked by a foreign object, e.g. button, coin or safety pin.
IMPORTANT: make sure that the water has cooled
before draining the washing machine.
35
Fig. C
EN