VALBERG WF 914 B S180C Consignes D'utilisation page 18

B
Using the appliance
PLEASE NOTE: Too much washing product can cause
excessive foaming, which will reduce washing efficiency.
If the washing machine detects too much foam, this will
disrupt the spinning process. Too little washing powder
will make laundry grey over time and produce limescale
in the heating system, drum and hoses.
15
Where to add the washing products
• The dispenser drawer has three compartments (fig. A).
15
20°C
20°C
Pre-wash compartment
• Washing product for pre-washing/soaking
15
Main wash compartment
• Washing product for washing
• Stain remover
• Water softener (water hardness, category 4)
Fabric softener compartment
• Fabric softener
• Liquid starch Pour in the additives without exceeding the "MAX" mark.
32
Fig. A
EN
B
Using the appliance
PLEASE NOTE: Keep the washing products in a secure,
dry place out of the reach of children.
• Washing liquids can be used for wash cycles with a
pre-wash. However, in this case, a washing powder
should be used for the main wash cycle.
• Do not use washing liquids when activating the
"Delayed start" function (if this is available on your
washing machine).
• To avoid an uneven distribution of product when using highly concentrated washing liquid
or powder, use the washing net or ball supplied with the appliance, and place it directly into
the drum.
• If you are using descaling agents, dyes or bleaches, make sure they are suitable for household
appliances. Descaling agents contain components that can damage the parts of your washing
machine.
• Do not put solvents in your washing machine (e.g. benzene, turpentine).
• If you are using starch powder, the procedure is as follows:
15
1. Wash your laundry using the program you want.
20°C
2. Prepare the starch-based solution, in accordance with the instructions provided by the
starch manufacturer.
3. Select the "Rinse + Spin" program, reduce the speed to 1000 rpm and start the program.
4. Pull the dispenser drawer towards you so that you can see approximately 3 cm of the main
wash compartment .
5. Pour the starch-based solution into the main wash compartment
in the dispenser drawer.
6. If you notice any starch residues in the dispenser drawer after the program has finished,
clean the main wash compartment.
33
15
20°C
while water is flowing
EN