VALBERG WF 914 B S180C Consignes D'utilisation page 6

B
Using the appliance
Levelling
• The washing machine should be installed on a firm, level surface (use a spirit level if
necessary). If you want to install the washing machine on a wooden floor, spread the weight by
placing a 60x60 cm plywood board, that is at least 3 cm thick, under the machine and secure
the board to the floor. If the ground is uneven, adjust the four adjuster feet as needed; do not
insert wooden blocks under the feet.
5. Unscrew the lock nut by turning it clockwise (see arrow) using the spanner.
6. Raise the machine slightly and adjust the height of the feet by rotating them.
Higher
7. Important: tighten the lock nut by turning it anticlockwise in relation to the machine.
Lower
8 EN
B
Using the appliance
Installing the bottom cover
8. Instructions for fitting the bottom noise reduction plate
• Place the fibreglass in the corner of the bottom plate, where it says "PUMP". Tilt the
washing machine by 30 to 40° to fit the bottom cover. Hold it with the side that has acoustic
insulation pointing upwards and the "PUMP" sign in the corner of the cover near the pump
of the washing machine.
Pump
• Before fitting the noise-reducing bottom plate, align the fibreglass with the printed mark
in the right-hand corner of the bottom plate and glue it (this is not necessary for models
without fibreglass).
• Remove the backing paper from the double-sided tape on all four edges of the bottom plate.
Double-sided tape
Pump
9 EN