After-Sales Service; Electrical Connection - VALBERG WF 914 B S180C Consignes D'utilisation

C
Useful information
If the error code UNB is displayed
Unbalance alert.
Press the "On/Off" button for 3 seconds to turn off the machine. Open the door and move the
clothes again, then turn the program selector to "Dehydration" mode. Run the spin cycle again.
If the error occurs again, disconnect the power supply and contact the after-sales
service.
42 EN
C
Useful information

After-sales service

Before calling the after-sales service:
1. Try to resolve the problem on your own (see the "Troubleshooting Guide" section).
2. Restart the program to check that the problem has been resolved.
3. If the problem persists, call the after-sales service.
Transport/handling
Never lift the appliance by the worktop when transporting it.
1. Disconnect the plug.
2. Close the water tap.
3. Disconnect the inlet and drain hoses.
4. Remove any water trapped in the pipes and in the appliance (see the "Removing the filter"
and "Draining residual water" sections).
5. Fit the transit bolts (required).
6. Given that the machine weighs more than 55 kg, two people are needed to move it.

Electrical connection

Make sure that the outlet has an earth connection.
• Do not use multi-sockets or extension cords.
• The power supply must be compatible with the rated current of the appliance, i.e. 10 A.
• The electrical connections must be made in accordance with the local regulations in force.
• The electric cable must only be replaced by a qualified electrician.
43 EN