VALBERG WF 914 B S180C Consignes D'utilisation page 7

B
Using the appliance
• Tilt the machine at an angle of 40° so that the side with the right-angled notch points towards
the front of the washing machine, as shown in the figure. Carefully insert the edge with the
oblique-angled notch between the two thumbscrews at the back of the washing machine.
Then fit the bottom plate making sure that it is in close contact with the bottom of the washing
machine.
• Manually press the double-sided tape along all four edges to firmly secure the noise-reducing
plate to the body of the appliance.
10
Pump
EN
B
Using the appliance
Connecting the water inlet hose
9. If the water inlet hose is not already installed, it must be screwed into the washing machine.
The hose with the blue mark is for supplying cold water only.
10. Screw the inlet hose onto the tap by hand and tighten the nut.
CAUTION:
• Do not make a knot in the hose!
• The washing machine must not be connected to the
mixer tap of a non-pressurised water heater.
• Check that the connections are watertight by turning
the water tap on fully.
• If the hose is too short, replace it with a pressure-
resistant hose of adequate length (1000 kPa min,
compliant with the EN 50084 standard).
• Regularly check the inlet hose for any weakness or
cracks, and replace it if necessary.
• The washing machine may be connected without a
non-return valve.
11
Cool
EN