To Clean The Spray Arms; To Clean The External Surfaces; What To Do If - AEG GS45BV220 Notice D'utilisation

7. Put the filter (B) to its initial position.
Make sure that it engages correctly in the
two guides (C).
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.

To clean the spray arms

Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a thin
pointed object.

To clean the external surfaces

Clean the external surfaces of the appliance and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (acetone).

WHAT TO DO IF...

The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device is on.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance does not fill with
water.
All manuals and user guides at all-guides.com
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet
hose is blocked.
The connection of the water
inlet hose is not correct.
Possible cause
What to do if...
Possible solution
Clean the water tap.
Contact your local water au-
thority.
Open the water tap.
Clean the filter.
Make sure that the connection
is correct.
79
C