Cleaning The Spray Arms; Internal Cleaning; External Cleaning; Troubleshooting - AEG FAVORIT 65050 VI1P Notice D'utilisation

30 www.aeg.com

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
6. Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7. Assemble the filter (A) and put it
back in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.

9.4 Internal cleaning

If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appli-
ance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.