External Cleaning; Internal Cleaning; Cleaning The Spray Arms; Troubleshooting - AEG FAVORIT 45502WO Notice D'utilisation

34 www.aeg.com
CAUTION!
An incorrect position of the
filters can cause bad
washing results and damage
to the appliance.

11.2 Cleaning the spray arms

Do not remove the spray arms. If the
holes in the spray arms are clogged,

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with
the help of the information in the table.
Problem and alarm code
You cannot activate the ap-
pliance.
The programme does not
start.
All manuals and user guides at all-guides.com
Possible solution
• Make sure that the mains plug is connected to the
• Make sure that there is no a damage fuse in the fuse
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for the
• The appliance has started the procedure to recharge
remove remaining parts of soil with a thin
pointed object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products,
abrasive cleaning pads or solvents.

11.4 Internal cleaning

• Carefully clean the appliance,
including the rubber gasket of the
door, with a soft moist cloth.
• If you regularly use short duration
programmes, these can leave
deposits of grease and limescale
inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per
month.
With some problems, the display
shows an alarm code.
mains socket.
box.
end of the countdown.
the resin inside the water softener. The duration of the
procedure is approximately 5 minutes.