Mio-Care Maintenance And Storage; Resolution Of Problems And Questions - I-Tech MIO-CARE Tens Mode D'emploi

8. MIO-CARE maintenance and storage.

We recommend that MIO-CARE is switched off and the cables are removed from the
connectors at the end of every session. MIO-CARE should be kept in the carry bag supplied,
together with the rest of the equipment supplied with it, and carefully stored on a secure
surface and protected from situations listed in the Warnings paragraph.
MIO-CARE should be stored in the following conditions:
Temperature:
Maximum relative humidity:
Atmospheric pressure:
Cleaning: only clean the device using a dry cloth.
We recommend a functional test carried out by the manufacturer every 24 months.
The manufacturer retains that the MIO-CARE device cannot be repaired by personnel external
to its own company. Any work of this nature carried out by personnel not authorised by the
manufacturer will be classed as tampering with the device, freeing the manufacturer from
responsibility for the warranty and hazards that the operator or user may be exposed to.
N.B. disconnect the cables before placing the electronic stimulator in the bag. If not, the cables
will bend excessively close to the connectors. This may damage the cables.

9. Resolution of problems and questions.

Any type of work on MIO-CARE must be carried out exclusively by the manufacturer or by an
authorised dealer. In any event, any presumed malfunction of MIO-CARE must be verified
before sending the device to the manufacturer.
Here below are some typical situations:
MIO-CARE cannot be turned on:
• Recharge the batteries and try to switch it on again; if it still does not switch on, check that
the power supply socket is working (red led on the battery charger on).
• Check that the ON/OFF button has been pressed correctly (held down for at least one second).
MIO-CARE does not transmit electric impulses:
• Check that the cable jacks have been inserted in the electrodes and that the plastic
protection has been removed from the electrode.
• Check that the cables have been connected correctly (connector well inserted in the device).
MIO-CARE switches off during operation:
• Recharge the batteries and start the treatment again. If the problem persists contact the
manufacturer.
Disposal
To protect the environment, the device, its accessories and above all the batteries must be
disposed of in areas equipped for that purpose or as special waste.
Product subject to WEEE regulations concerning separate waste collection: when disposing this
product, please use the designated areas for disposing electronic waste or contact the manufacturer.
IACER S.r.l.
from +5° C to +40° C
80%
from 700 hPa to 1060 hPa
39
MNPG04 Rev. 03 Ed. 02/09