Table des Matières
Publicité
EZ Zone Series RM
WATLOW
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following Series RM (Rail Mount) products:
Model Numbers:
Classification:
Voltage and Frequency:
Power Consumption:
Environmental Rating:
Meet the essential requirements of the following European Union Directives by using the relevant standards show
below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1
2006
EN 61000-4-2
1996
EN 61000-4-3
2006
EN 61000-4-4
2004
EN 61000-4-5
2006
EN 61000-4-6
1996
EN 61000-4-11
2004
EN 61000-3-2
2005
2
EN 61000-3-3
2005
2
NOTE 1: To comply with flicker requirements cycle time may need to be up to 160 seconds if load
current is at 15A, or the maximum source impedance needs to be < 0.13Ω Ω Ω Ω . Control power input of RM
models comply with 61000-3-3 requirements.
EN 61010-1
2001
Per 2002/96/EC W.E.E.E Directive
Raymond D. Feller III
Name of Authorized Representative
General Manager
Title of Authorized Representative
CE DOC EZ-ZONE RM-10-09
Modu le RM L Watl ow EZ - ZON E
Declaration of Conformity
RM followed by additional letters or numbers describing use of up to four module
options of various inputs and outputs or communications.
Temperature control, Installation Category II, Pollution degree 2
SELV 24 to 28 V ac 50/60 Hz or dc
RMA models 4 Watts, any other RM model 7 Watts
IP20
Electrical equipment for measurement, control and laboratory
use – EMC requirements, Industrial Immunity, Class A
Emissions (Not for use in a Class B environment without
additional filtering).
A1, A2, 2001
Electrostatic Discharge Immunity
Radiated Field Immunity
Electrical Fast-Transient / Burst Immunity
Surge Immunity
A1, A2, A3, 2005
Conducted Immunity
Voltage Dips, Short Interruptions and Voltage Variations Immunity
Harmonic Current Emissions
Voltage Fluctuations and Flicker
2006/95/EC Low-Voltage Directive
Safety Requirements of electrical equipment for measurement,
control and laboratory use. Part 1: General requirements
Compliant with 2002/95/EC RoHS Directive
Winona, Minnesota, USA
Place of Issue
Signature of Authorized Representative
Page 1 of 1
®
ISO 9001
an
Please Recycle Properly
10 1
•
•
approved facility since 1996.
Oct. 2009
Date of Issue
An ne x e
Publicité
Table des Matières
